Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Columbia, SC

CHI Overhead Doors Garage Door Roller Replacement in Columbia, SC

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

CHI Overhead Doors Garage Door Roller Replacement is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Whether your CHI Overhead Doors garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Signs you need CHI Overhead Doors garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

What usually causes it

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

Before the technician arrives

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle CHI Overhead Doors garage door roller replacement

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

CHI Overhead Doors Garage Door Roller Replacement cost in Columbia, SC

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

CHI Overhead Doors Garage Door Roller Replacement in Columbia, SC

Humid air in South Carolina rusts cables, roller bearings and hinges, which makes the door noisy and heavy and eventually makes the opener strain.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Technicians serve all of Columbia (ZIP codes 29201, 29202, 29203, 29204, 29205 and more), plus West Columbia (2.3 mi), Forest Acres (2.9 mi), Cayce (3.3 mi) and Saint Andrews (4.8 mi). Call (833) 435-8883 to book a visit in Columbia.

CHI Overhead Doors Garage Door Roller Replacement: frequently asked questions

How much does CHI Overhead Doors garage door roller replacement cost in Columbia, SC?

CHI Overhead Doors Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where South Carolina or Columbia requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Columbia, SC

Overhead Door Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Midland Garage Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Martin Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Wayne Dalton Extension Spring Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$350

Clopay Torsion Spring Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $200-$450

Garaga Garage Door Track Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$400

Overhead Door Extension Spring Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$350

Richards-Wilcox Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Sommer Opener Gear & Sprocket Replacement

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$275

Garaga Off-Track Garage Door Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $175-$450

Wayne Dalton Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Columbia, SC now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote